MMH  >  Rooms  >  Other Room

How can I erase the memory on my garage door opener when you say it could be full?

After reading several of your Q. & A. I think I need to erase the memory on my garage door opener model # 139.53672srt3 , could you tell me how to do this? I changed the batteries in one of the remotes for the door opener , and I can only get one opener to work at a time. I have three cars and want a remote in all three. Or is there anything else that I could try to do to fix this problem?

The programming information below will apply to your model and includes information on how to clear the memory/erase all codes.

To program a transmitter/remote, do the following:

1. Press and hold the selected remote push button.

2. Then press and release the "SRT" (learn) button on the back panel of the opener. The opener light will flash once.

3. Release the remote push button.

Now the opener will operate when the remote control button is pressed.

If you decide to use a different remote control button than originally programmed into the opener, you need to erase all the learned codes and reprogram each remote control used to operate the garage door opener.

To erase all codes:

1. Press and hold the "SRT" button on the opener panel until the indicator light turns off (about 6 seconds). All the codes the opener has learned will be erased.

2. Repeat steps 1,2, and 3 above for each remote control in use.

The programming procedures are also listed in the Owners Manual and on the Opener panel.